Changes
Page history
Update Using Altium
authored
Mar 29, 2024
by
Alia Peterson
Show whitespace changes
Inline
Side-by-side
Using-Altium.md
View page @
fa566356
...
@@ -144,3 +144,23 @@ To make a new symbol:
...
@@ -144,3 +144,23 @@ To make a new symbol:
1.
You can also adjust the size of the holes - Diameter 25mil and hole size 15mil is a good size.
1.
You can also adjust the size of the holes - Diameter 25mil and hole size 15mil is a good size.
</details>
</details>
<details><summary>
Tips and Tricks:
</summary>
-
To find a library that you've opened, click on the bottom left - SCH Library
-
Push space while dragging a component or net label to make it rotate.
-
When saving things, the little red file symbol on the left in the projects panel turns gray.
-
Navigating 3d mode:
-
Hold down shift and drag with right click to rotate the board to view from different angles
-
Click 0 to orient the board horizontally (rotated 0 degrees)
-
Click 9 to orient the board vertically (rotated 90 degrees)
-
Click 8 to orient the board from the house view.
-
Changing the size of the grid - Type “g” to change the grid size
-
Switch between measurement units - type “q”. We prefer mil (1000th of an inch) over mm.
-
You can see which one you’re currently using by looking to the bottom left where it describes the grid and the dimensions and units.
-
You can keyboard shortcut into the menus and options by typing the underlined letter
-
Ctrl + scroll in and out to zoom in and out
-
Right click drag to move the board around
-
To measure - Ctrl m
-
To clear measurements - Shift c
</details>
\ No newline at end of file