Update Using Altium authored by Alia Peterson's avatar Alia Peterson
...@@ -144,3 +144,23 @@ To make a new symbol: ...@@ -144,3 +144,23 @@ To make a new symbol:
1. You can also adjust the size of the holes - Diameter 25mil and hole size 15mil is a good size. 1. You can also adjust the size of the holes - Diameter 25mil and hole size 15mil is a good size.
</details> </details>
<details><summary>Tips and Tricks:</summary>
- To find a library that you've opened, click on the bottom left - SCH Library
- Push space while dragging a component or net label to make it rotate.
- When saving things, the little red file symbol on the left in the projects panel turns gray.
- Navigating 3d mode:
- Hold down shift and drag with right click to rotate the board to view from different angles
- Click 0 to orient the board horizontally (rotated 0 degrees)
- Click 9 to orient the board vertically (rotated 90 degrees)
- Click 8 to orient the board from the house view.
- Changing the size of the grid - Type “g” to change the grid size
- Switch between measurement units - type “q”. We prefer mil (1000th of an inch) over mm.
- You can see which one you’re currently using by looking to the bottom left where it describes the grid and the dimensions and units.
- You can keyboard shortcut into the menus and options by typing the underlined letter
- Ctrl + scroll in and out to zoom in and out
- Right click drag to move the board around
- To measure - Ctrl m
- To clear measurements - Shift c
</details>
\ No newline at end of file